Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Solution operation and attribute features selection

Posted 5 avr. 2012, 03:13 UTC−4 Heat Transfer & Phase Change, Studies & Solvers Version 4.2a 0 Replies

Benjamin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am modelling a vacuum chamber which is cooled by LN2. Since it works in the vacuum I only have radiative heat transfer in it.

I have trouble to choose the correct operation and attribute features, depending on the ones I choose, the temperature I obtain on a specific place go from 100 to 200 [K].

I choose a stationary solver, the more credible results are with a stationary (linear) solver with coupled and iterative or direct attribute. However if I choose the same combination with nonlinear solver, I have strange results.
Finally when I choose segregated, all the results seem not credible.

Have you any idea how to justifiy the selection of these features?

Thank you very much!
0 Replies Last Post 5 avr. 2012, 03:13 UTC−4
COMSOL Moderator

Hello Benjamin

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content