Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Model 3D Geometry using Crosssections
Posted 2 mars 2012, 15:31 UTC−5 Geometry Version 4.2a 1 Reply
Please login with a confirmed email address before reporting spam
I recently modeled an integrated optics component using Comsol 4.2a. I managed to parametrize any appearing cross-section using only one remaining parameter, the position in the propagation direction of the light. I used this to model the optical waveguide mode along the structure, which helped making a number of design decisions. Now I want to finalize the design and run a full 3D simulation, but I have some trouble drawing the structure.
Is there a easy way to draw a 3D structure by connecting a number of 2D cross-sections? I remember there was a command 'loft' in 3.5a with the matlab interface, but I can not find that for 4.2a. Any other ideas?
Thanks a lot.
Niklas
Hello Jan Niklas Caspers
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
Use the lofting capability, available in the Design Module: www.comsol.com/design-module
Best regards,
Jeff