Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Electric potential induced by DC current -- Equation used in COMSOL 3.5

Posted 29 févr. 2012, 11:08 UTC−5 0 Replies

Kanuengnit Marongmued
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear community,

I have created a stack of material and bias DC current for monitor electric potential in COMSOL ver 3.5, heat trasfer module. I use "Postprocessing --> Boundary integration --> Electric potential (Express V: Unit V.m^2) and then select boundary for monitor electric potential accross stack. I want to know the equation that COMSOL use to calculate this value. And if I want to get the location at the boundary that has the maximum potential , how to do that??

Thx so much,

Kanuengnit
0 Replies Last Post 29 févr. 2012, 11:08 UTC−5
COMSOL Moderator

Hello Kanuengnit Marongmued

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content