Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Error when Compiling Equations: The DAE is structurally inconsistent.
Posted 11 mai 2020, 04:06 UTC−4 Electromagnetics, Low-Frequency Electromagnetics Version 5.5 0 Replies
Please login with a confirmed email address before reporting spam
Hi, I'm new here and still struggling to figure out the step by step process to run a simulation. I'm trying to simulate a magnetic field from feeding a Sine AC wave to a copper coil. I've generated a Helix (copper) and a Sphere (air) around it. I used a partition to separate the coil into two sides, and conencted the P node of the Voltage Source to one side, and the N node of the Voltage source to the other side. I've been receiving the 'Error when Compiling Equations: The DAE is structurally inconsistent.' message no matter how i try to change the nodes. I've attached screenshots below. Any help would be greatly appreciated. Thank you!
Attachments:
Hello Jenny Smith
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.