Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

apply voltage

Please login with a confirmed email address before reporting spam

How to apply voltage to the model? Thank you very much for helping me.


1 Reply Last Post 6 mars 2020, 09:49 UTC−5
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 6 mars 2020, 09:49 UTC−5

It's difficult to give you a specific answer without knowing the context, but often voltage is applied to a model as a boundary condition. The busbar model featured in the Introduction to COMSOL Multiphysics manual (found under File > Help > Documentation, and here ) illustrates this for a DC situation. Electrostatics is very similar. If you work with other physics, browse through the Applciation Gallery for examples similar to yours, or provide more details in this thread so users of this Discussion Forum can provide more specific help.

Best,

Jeff

-------------------
Jeff Hiller
It's difficult to give you a specific answer without knowing the context, but often voltage is applied to a model as a boundary condition. The busbar model featured in the Introduction to COMSOL Multiphysics manual (found under File > Help > Documentation, and [here](https://cdn.comsol.com/doc/5.5/IntroductionToCOMSOLMultiphysics.pdf) ) illustrates this for a DC situation. Electrostatics is very similar. If you work with other physics, browse through the [Applciation Gallery](https://www.comsol.com/models) for examples similar to yours, or provide more details in this thread so users of this Discussion Forum can provide more specific help. Best, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.