Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
How to plot experimental data with simulated data
Posted 7 janv. 2012, 16:34 UTC−5 Low-Frequency Electromagnetics Version 4.2a 0 Replies
Please login with a confirmed email address before reporting spam
1. How can I include my experimental data with simulated 1D line graph results (i.e I want to include my experiment data points inside modeling results plot.).
2. Is there away to get results at speciafic points (ex, x=1,1.5, 2....20[mm]) instead of all the data that gives from COMSOL results.
3. I want to get a results in a diagonal direction of a box. When i use free tetrahedral mesh, diagonal direction mesh elements are not properly located. (I can't use mapped and sweep function as there is another box inside). How can I get clean, specific number of mesh elements located on dioganal direction.
4. I want to check the results convergence. Can anyone tell me the procedure or provide a place that I can get this information.
I know there's lot of questions. Appreciate if you can help at least on few.
Hello Chamila Siyambalapitiya
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.