Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Beam Uncurling
Posted 9 mai 2019, 16:58 UTC−4 Structural & Acoustics, Structural Mechanics Version 5.2a 0 Replies
Please login with a confirmed email address before reporting spam
I have a curved beam that I am attempting to uncurl by keeping one end in place with a prescribed displacement) and applying a prescribed displacement on one point on the other end which should move it into an uncurled configuration. However, the model will not complete the full displacement (several millimeters in the x and y directions) and stops after about 0.2 mm displacement. Any suggestions are appreciated.
Attachments:
Hello Allison
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.