Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Mesing a geometry with micrometer to nanometer features
Posted 9 oct. 2011, 22:28 UTC−4 Mesh Version 3.5a 1 Reply
Please login with a confirmed email address before reporting spam
Hi
I am trying to mesh two concentric circles of micron diameter (say 10 microns). But the difference between the diameters of the two circles is of nanometer range (1-5nm), i.e. one circle is of 10microns diameter and the other one is 10um+5nm diameter. During meshing, I am getting errors. Is there any way to fix this problem?I would appreciate any of the experts help. I am using COMSOL v3.5a.
Thanks
Imran
I am trying to mesh two concentric circles of micron diameter (say 10 microns). But the difference between the diameters of the two circles is of nanometer range (1-5nm), i.e. one circle is of 10microns diameter and the other one is 10um+5nm diameter. During meshing, I am getting errors. Is there any way to fix this problem?I would appreciate any of the experts help. I am using COMSOL v3.5a.
Thanks
Imran
1 Reply Last Post 11 oct. 2011, 07:56 UTC−4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
check your geomemtry absolute and relative resolution settings (not sure anymore where they are in 3.5, probably in the options and geoemtry tab) to be sure the items are resolved
the next issue is that from nm to um there are 6 orders of magnitude, that is probably too much for the mesher in one go, one way around is to add an intermediate internal boundary so you reduce the aspec rations to at most 1:10'000, then mesh in 2 steps, higest resolution first, coarse at the end
--
Good luck
Ivar
check your geomemtry absolute and relative resolution settings (not sure anymore where they are in 3.5, probably in the options and geoemtry tab) to be sure the items are resolved
the next issue is that from nm to um there are 6 orders of magnitude, that is probably too much for the mesher in one go, one way around is to add an intermediate internal boundary so you reduce the aspec rations to at most 1:10'000, then mesh in 2 steps, higest resolution first, coarse at the end
--
Good luck
Ivar