Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Two tolerance factors for segregated solver?
Posted 7 mars 2019, 17:07 UTC−5 Structural & Acoustics, Fluid & Heat, Studies & Solvers Version 5.4 0 Replies
Please login with a confirmed email address before reporting spam
Hi, everyone:
I am using the segregated solver to do a time-dependent simulation. I found there are two settings for the tolerance factors: one is in the general setting of this solver, and the other is in each step of the solver. So I am wondering how we calculate the absolute tolerance based on these settings? For example, if the relative tolerance is 0.01, the tolerance factor in the general setting is 0.01, and the tolerance factor in each step is 0.1, then the absolute tolerance is 0.01×0.01×0.1? or just 0.01×0.01? In addition, a third tolerance factor in the settings of Time dependent solver is also found. I am very confused by the relationship of these three tolerance factors.
Could you please do me a favor?
Thank you for your help and time.
-------------------Yu Zhang
Hello Yu Zhang
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.