Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
sedimentation tank with mixture model, laminar flow
Posted 2 sept. 2011, 14:21 UTC−4 Fluid & Heat, Geometry, Results & Visualization Version 4.4 1 Reply
Please login with a confirmed email address before reporting spam
The reason I write to you is because I am in a research project on optimization in the design of sedimentation tanks, then I'm applying computational fluid dynamics as a fundamental tool.
as the essence of sediemntadores is working with a continuous phase and a dispersed phase at the moment I'm running the model with "Mixture Model, Laminar flow" but I get an error saying that the matrix has values of zero on the diagonal .
thank you very much, I expect an answer.
Hello Andres Felipe Villarreal
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
I am at the beginner level of COMSOL(elementary school - kindergarten ;) ). I am wondering if you find your solution after years, as I am trying to develop similar model.
My problem is particle tracing. I am not sure, should I go through two modules of mixture model, laminar flow and particle tracing, or only with mixture model? As my concern is the movement of particles in water.
Look forward to hearing from you.
Best regards
Masoumeh