Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Change the geometry afterwards

Posted 9 août 2018, 15:49 UTC−4 General, Heat Transfer & Phase Change, Geometry Version 5.3 0 Replies

Shengyue Shan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am really curious whether it is possible to change the geometry after all the parameters and variables are put in. Because currently I am defining the geometry of this model as 2D asymmetric to simplify my problem, but the real geometry for this model should be 3D.

Thank you very much for your help!

Best regards, Shengyue Shan

0 Replies Last Post 9 août 2018, 15:49 UTC−4
COMSOL Moderator

Hello Shengyue Shan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content