Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Coupling between Mindlin Plate(s) and Air domain - Transient Analysis
Posted 13 juin 2011, 06:31 UTC−4 0 Replies
Please login with a confirmed email address before reporting spam
I'm trying to couple 3 circular plates to a Y-shaped (consists of 3 cylinders - each end of y has a different disc, 2 same size and one smaller) air domain and carry out a transient analysis of the coupled system. (Currently using structural mechanics module mindlin plate and acoustics module pressure acoustics)
I have no problem building the geometry but I'm trying to use a new geometry and new physics for each disc and I'm struggling to couple more than one disc to the correct place on the y shaped air domain.
Additionally I would like to apply two harmonic loads to one disc, that is, stimulate it with 2 slightly different frequencies simultaneously and am looking for the best solution to achieve this.
Any ideas or comments are most welcome!
Kind regards
David
Hello David Mackie
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.