Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Convergence while connection of PSPice circuit
Posted 24 avr. 2011, 18:35 UTC−4 Low-Frequency Electromagnetics, Studies & Solvers Version 3.5a 1 Reply
Please login with a confirmed email address before reporting spam
Hello. I simulate two parts in COMSOL. The first is geometry part and the second - created by pspice. They are connected between each other by means of COMSOL tools. During simulation I've got convergence around 3e+8. What does it mean? Are obtained results correct? Where I could got more information about convergence? Thanks for any helping/information.
1 Reply Last Post 25 avr. 2011, 03:38 UTC−4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
it does not seem to be very good convergence, in my understanding should tend towards "=0". Perhaps you should check the scaling values, you might get some more info if you turn on the "detailed" log info (v4) or study the log file in 3.5
--
Good luck
Ivar
it does not seem to be very good convergence, in my understanding should tend towards "=0". Perhaps you should check the scaling values, you might get some more info if you turn on the "detailed" log info (v4) or study the log file in 3.5
--
Good luck
Ivar