Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Partical Tracing for Fluid Flow doesn't working

Posted 9 août 2017, 06:25 UTC−4 Fluid & Heat Version 4.3b 0 Replies

NDN UNIST/Mechanical Engineering
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all
I am doing an Electroosmosis flow simulation with Creeping Flow, Electric Current and Particle Tracing for Fluid Flow module.

the streamline of fluid velocity indicates that there are the electroosmosis flows around the electrode that means my setups are correct.

In this case, Particle Tracing worked properly by moving particles along streamlines

But when I changed my BCs setting for Fluid flow like:
Inlet: Pressure =0
Outlet: Pressure =0

That means no flow in and out.

And in this case, Particle Tracing does not work. Particles no moving.

I had added Drag Force for both cases

So, what is my mistake ???

Best regards


0 Replies Last Post 9 août 2017, 06:25 UTC−4
COMSOL Moderator

Hello NDN

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content