Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Fatigue Analysis
Posted 6 mars 2011, 03:38 UTC−5 Version 4.0, Version 4.1 0 Replies
Please login with a confirmed email address before reporting spam
I have a somewhat general question in the sense that I have not started anything concrete yet. I want to run a fatigue analysis on a valve I am modeling. I am unsure however, of how to go about doing this in an FEA environment such as COMSOL.
I feel as though, this may be very difficult to achieve in COMSOL. My initial thoughts were to just cycle the applied load at a given frequency over a transient period of time and have the solver use each iterative solution as the initial condition for the following solution. My model shows a maximum stress of about 1/10th its yield strength, leading me to believe that even an instantaneous release of boundary load will just cause the model to return to its initial state before any load ever happened. In this case, no fatigue would be noticeable rendering the study useless...
Any quick ideas someone would like to share? or maybe some links to literature on the topic?
Thank you for your time,
Daniel
Hello Dan Student
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.