Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Change Parameters during study

Please login with a confirmed email address before reporting spam

Hi all. I have set up a model looking at the concentrations of nutrients. It is hard to explain but I have set up my initial parameters as follows,

I have an initial number of cells;

cells=5000

After the model solves it gives me the concentration of nutrients, but is there a way to set up the model that when the concentration reaches a critical level, say 1mM, then cells begin to die.

So can I loop my model to say something like

cells=if concentration<1mM then cells = 4000 and so on...

Im sorry if this makes no sense but its hard to explain. I would really appreciate any help.

Kind regards

0 Replies Last Post 6 juin 2017, 10:50 UTC−4
COMSOL Moderator

Hello Mike Duffy

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.