Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Model Parameter Adjustment

Posted 20 oct. 2016, 16:36 UTC−4 Fluid & Heat, Interfacing, Computational Fluid Dynamics (CFD), Porous Media Flow, Geometry, Studies & Solvers, Structural Mechanics Version 5.2a 0 Replies

Femi Oyedokun
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Is there an operator I can use to determine the position where the average value of a dependent variable (of a 2D geometry) will reach a particular value? To be clearer;

I have a three PDE that I am solving simultaneously, one of the dependent variables is porosity. My target is to determine the position along the length of the domain where the average porosity along the vertical axis of the domain reaches 1. I know that looking at the GUI I can see it after the study is computed. But I need this information to adjust one of the parameters of the model, if possible, before computing; as the adjustment is inherently coupled with the variation of the porosity distribution.

Thanks.

Femi Oyedokun
0 Replies Last Post 20 oct. 2016, 16:36 UTC−4
COMSOL Moderator

Hello Femi Oyedokun

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content