Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problem in Meshing

Posted 14 sept. 2016, 06:12 UTC−4 RF & Microwave Engineering, Heat Transfer & Phase Change, Computational Fluid Dynamics (CFD), Mesh, Modeling Tools & Definitions, Parameters, Variables, & Functions, Studies & Solvers 1 Reply

Hakan Nigar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi there,
I have a model which works fine and whenever I want to increase the mesh element from normal to fine it gives me an error, i.e. Error in user-defined function. I really do not understand this situation, Why?
Any explanation please?
1 Reply Last Post 14 sept. 2016, 06:14 UTC−4
François Mandias COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 14 sept. 2016, 06:14 UTC−4
Dear Hakan Nigar,

Please address your post directly to: support@comsol.com

Best,
François
Dear Hakan Nigar, Please address your post directly to: support@comsol.com Best, François

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content