Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
unknown unit error in COMSOL4.0
Posted 30 nov. 2010, 22:23 UTC−5 1 Reply
Please login with a confirmed email address before reporting spam
hi, everyone!
I am a COMSOL4.0 beginner. I simulated a simple 2D-piezoelectric SAW modal. It 's a reatangle in attachment file. Its boundary conditions consisted periodic boundary on two sides and fixed constraint on bottom. When I used m, cm, mm units system, it could work , only many warnings, 'The relative residual is greater than the relative tolerance. Relative residual 8.5e-014 Relative error 1e+002' . However, when i used um unit system, a error occured, 'Unknown unit - Unit: ?m'.
Locate the Geometry Settings section. Find the Units subsection. From the Length unit list, select µm
Thanks for consideration, any help is appreciated.
I am a COMSOL4.0 beginner. I simulated a simple 2D-piezoelectric SAW modal. It 's a reatangle in attachment file. Its boundary conditions consisted periodic boundary on two sides and fixed constraint on bottom. When I used m, cm, mm units system, it could work , only many warnings, 'The relative residual is greater than the relative tolerance. Relative residual 8.5e-014 Relative error 1e+002' . However, when i used um unit system, a error occured, 'Unknown unit - Unit: ?m'.
Locate the Geometry Settings section. Find the Units subsection. From the Length unit list, select µm
Thanks for consideration, any help is appreciated.
Attachments:
1 Reply Last Post 1 déc. 2010, 03:04 UTC−5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
there are several weakness in V4.0 concerning default solver settings used, so there are a few fileds to tewak, often the results are still usable even with these warnings. I can only suggest to call your rep and get hands on the latest 4.1 version, the handling of these solver issues are greatly improved
--
Good luck
Ivar
there are several weakness in V4.0 concerning default solver settings used, so there are a few fileds to tewak, often the results are still usable even with these warnings. I can only suggest to call your rep and get hands on the latest 4.1 version, the handling of these solver issues are greatly improved
--
Good luck
Ivar