Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Warning: SOR line did not find any lines.
Posted 30 avr. 2016, 16:30 UTC−4 Fluid & Heat, Microfluidics, Studies & Solvers Version 4.3b, Version 5.0 0 Replies
Please login with a confirmed email address before reporting spam
I am running a laminar two-phase flow (level set) simulation with a 3D geometry. I had previously simulated the same geometry in 2D with the same initial values and boundary conditions and have no problem reaching a solution. However, when I try to run the simulation with a 3D geometry, the warning "SOR line did not find any lines" keeps coming up and eventually I get error saying
Nonlinear solver did not converge.
Divergence of the linear iterations.
Time : 0
Last time step is not converged.
Has anyone encountered this warning before and know what to do with it? Thanks a lot in advance!
Hello C Yu
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.