Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Importing solidwork data into comsol

Posted 23 févr. 2016, 22:56 UTC−5 Fluid & Heat, Computational Fluid Dynamics (CFD) Version 4.2 0 Replies

薩 莫
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi there

I have a problem in importing solidwork products into comsol where the measurements (in meters) are changed in big amount. As experienced, i import an image of dimension 10x10x25 in meters from solidwork. After importing, the new measurement of that image is 4000x4000x4000 meters in comsol.

Is there anyone know the problem behind this situation? I use a 4.2 version.

Thanks in advance.
0 Replies Last Post 23 févr. 2016, 22:56 UTC−5
COMSOL Moderator

Hello 薩 莫

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content