Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Surface Pressure Integration Problem under the Laminar Flow Physics

Posted 17 oct. 2010, 22:27 UTC−4 0 Replies

Jinzhou Yuan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

I experienced two problem when doing my simulation under the Laminar Flow Physics. My COMSOL version is 4.0a.

Please refer to the attachment for detailed model information.

Problem 1. I cannot get convergence solution after I changed the mesh density (element size) from "Normal" to "Fine";

Problem 2. When I did the Surface Pressure Integration in COMSOL, I found that the results I got are highly dependent on the "Point Pressure Constraint" value which is not right since in Navier–Stokes equation, there is one term related with the gradient of pressure, and therefore, the solution should dependent only on the gradient of pressure rather than pressure itself.

Does anybody else experienced the same problems with me?

Thank you in advance.

Jinzhou

Attachments:

0 Replies Last Post 17 oct. 2010, 22:27 UTC−4
COMSOL Moderator

Hello Jinzhou Yuan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content