Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Ecap simulation in COMSOL

Posted 3 oct. 2015, 00:00 UTC−4 Fluid & Heat, Heat Transfer & Phase Change, Mesh, Parameters, Variables, & Functions, Studies & Solvers, Structural Mechanics Version 4.4, Version 5.1 0 Replies

Monica Conejo
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi!

I have to simulate an ecap process with Comsol. The ecap is basically a severe plastic deformation process where a billet is pass trough a die with two channels intersecting at a 90° angle (or higher).

Has anyone of you tried to simulate this process on Comsol before? For the papers I've read it has been done a lot but in Abaqus, Qform and others, none of them in Comsol.

Can you give me any recommendation on how to do it?

Thanks in advance for any help you can give me.
0 Replies Last Post 3 oct. 2015, 00:00 UTC−4
COMSOL Moderator

Hello Monica Conejo

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content