Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Materials in comsol 4.0
Posted 29 août 2010, 18:38 UTC−4 1 Reply
Please login with a confirmed email address before reporting spam
Using High Density polyethylene for a phase change problem and there is a stop sign in properties called Tempref. How can this be fixed. what value is required or shoul I look for
1 Reply Last Post 30 août 2010, 02:08 UTC−4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
When you use library materials, these are often defined with respect to temperature and pressure variations, therefore you must ensure you also define the working temperature and pressure (sometimes there are also other variables to define)
Tempref is typically the reference temperature you are to consider, but this is model dependent, check the doc and think it over based on your model what is really happening during the phase change (start and top states ...
--
Good luck
Ivar
When you use library materials, these are often defined with respect to temperature and pressure variations, therefore you must ensure you also define the working temperature and pressure (sometimes there are also other variables to define)
Tempref is typically the reference temperature you are to consider, but this is model dependent, check the doc and think it over based on your model what is really happening during the phase change (start and top states ...
--
Good luck
Ivar