Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

3D model electric field simulation problem when 2D model Electric field plot works fine

Please login with a confirmed email address before reporting spam

Hey all,

I really need your help in the plots of Electric field simulation.

for 2D:
I made simple 2 rectangle of electrodes (copper )with a circle of air around it and then used physics Electrostatics (es) and gave potential to copper rectangels and I get beautiful results of electric field distribution in 2D. I am plotting norm.E and even once put the whole expression of magnitude of E field.

for 3D:

following the same procedure, I made two cylindrical electrodes (copper) and a sphere of air around them. and when the results gave plots its almost nothing.

Please help me. I am confused and can not pin point at what I am doing wrong.

I have attached the files too


0 Replies Last Post 13 mai 2015, 04:05 UTC−4
COMSOL Moderator

Hello Maryam Javed

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.