Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Stationary Study and Time Dependent Study of Same Model Disagree
Posted 30 avr. 2015, 19:50 UTC−4 Low-Frequency Electromagnetics, MEMS & Nanotechnology, Plasma Physics, MEMS & Piezoelectric Devices, Battery Design, Materials, Modeling Tools & Definitions, Parameters, Variables, & Functions, Results & Visualization, Studies & Solvers Version 4.4 0 Replies
Please login with a confirmed email address before reporting spam
I'm running an electric currents interface for a dielectric board with a couple ground points and a constant current source within the dielectric. I'm interested in the transient solution to this problem (how the voltage approaches steady state) so I'm running a time dependent study.
To generate initial conditions for my time dependent study, I also ran a stationary study for my current source x 10^-6. I used the solution of the stationary study as the initial conditions for my time dependent study. To check the results of my time dependent study, I also ran the stationary study with the correct current source. The steady state solution of my time dependent study significantly disagrees with the solution of the stationary study.
Does anyone know what my problem is? I suspect it has to do with the initial conditions.
Thanks!
James
Hello James Chinn
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.