Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

[simple question] defining an integration function after solving model does not work

Posted 12 déc. 2014, 22:15 UTC−5 2 Replies

Ali Hemmatifar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

I have solved a model and I have the results. Now, I need to do some post-processing on my data. I defined an integration function in "Definitions" thread. But once I try to use it in the "Results" for plotting data for example, I get "Unknown function or operator" error. I have the same problem with any function that is defined AFTER solving step.

Is there any way to get it to work without solving the whole model again?

Thanks!
2 Replies Last Post 13 déc. 2014, 16:21 UTC−5
mts
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 13 déc. 2014, 07:46 UTC−5
Hello,

try to "Update Solution" (for further information have a look at the reference manual). I think this will fix your problems.

Best regards,
Maximilian
Hello, try to "Update Solution" (for further information have a look at the reference manual). I think this will fix your problems. Best regards, Maximilian
Ali Hemmatifar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 13 déc. 2014, 16:21 UTC−5
Thanks. Worked fine!
Thanks. Worked fine!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content