Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Joule heating simulation question.

Posted 2 oct. 2014, 21:38 UTC−4 0 Replies

Jeremy Paul
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi there,

I'm looking to simulate a thermal micro-actuator with a variety of current/voltage pulses occuring in different durations or in sequence, and in different input locations. How would I best set up conditions and a study to accomplish :

-Having actuation signals of different durations
-Having an actuation signal come in at one point, turn off, and then have another actuation signal come in at another point
-Having these occur in different sequences?


Kind Regards!
0 Replies Last Post 2 oct. 2014, 21:38 UTC−4
COMSOL Moderator

Hello Jeremy Paul

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content