Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

3d Metamaterial simulation

Posted 18 sept. 2014, 13:16 UTC−4 Low-Frequency Electromagnetics Version 4.3b 2 Replies

Hongzhi Guo
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi

I am trying to simulate a 3d metamaterial cylinder. I build a cylinder and set its relative permeability as -1. the source is a coil inside it. However, the simulation does not converge. Does anyone have idea on this?
2 Replies Last Post 10 juil. 2017, 08:24 UTC−4
Hongzhi Guo
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 18 sept. 2014, 13:16 UTC−4
Also I tried positive permeability, it works well
Also I tried positive permeability, it works well
Shant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 10 juil. 2017, 08:24 UTC−4
You have to use Transition boundary condition on the metamaterial boundary when using negative refractive index, likewise this case www.comsol.com/model/modeling-a-negative-refractive-index-wave-optics-14687
You have to use Transition boundary condition on the metamaterial boundary when using negative refractive index, likewise this case https://www.comsol.com/model/modeling-a-negative-refractive-index-wave-optics-14687

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content