Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Study1 is sweep of the wavelength and the consequence is used in Study 2, but how to get the curves of Study 2 which is sweep the wavelength of Study 1?
Posted 14 juil. 2014, 22:44 UTC−4 Low-Frequency Electromagnetics, RF & Microwave Engineering, Studies & Solvers Version 4.4 2 Replies
Please login with a confirmed email address before reporting spam
I'm puzzled that how to calculate the EQE of the solar cell , I used the light(rf module) to calculate the G (sweep of the wavelength) and electrostatics1 to calculate the phi0; two transport of diluted species to calculate the nc & pc; electrostatics 2 to calculate the phi. I want to get the EQE with the function of wavelength, and the J-V profile, but don't know how to set the whole module, Study1 is sweep of the wavelength and the consequence is used in Study 2, but how to get the curves of Study 2 which is sweep the wavelength of Study? Could you help me to check and modification my .mph file?and Thank you very much！
Attachments:
Hello Xi Yang
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
I have the similar problems with you. Now, could you to simulate right results? if you success, could you sent the model to me ? my email address: 863zhoujian@tongji.edu.cn
thank you.
Please login with a confirmed email address before reporting spam
thank you.