Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Water Temperature in Induction Coil

Posted 26 mars 2014, 15:05 UTC−4 Electromagnetic Heating, Low-Frequency Electromagnetics Version 4.3a 0 Replies

Diana David
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Is there a way to define a domain/boundary for the inlet and outlet flow of water in a multi-turn coil using the induction heating interface? My model is similar to the "Inductive Heating of a Copper Cylinder" model. I just modified it a bit to coincide with my lab set-up. I am monitoring the water inlet and outlet temperature experimentally so I want to make sure that these measurements and my model's predictions are consistent.

Thanks in advance!
0 Replies Last Post 26 mars 2014, 15:05 UTC−4
COMSOL Moderator

Hello Diana David

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content