Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
4.4 Software problem
Posted 21 févr. 2014, 07:38 UTC−5 Mesh Version 4.4 1 Reply
Please login with a confirmed email address before reporting spam
Hello,
I just noticed a disturbing thing in COMSOL 4.4 (the equivalent of windows 8 in terms of GUI horribleness in my opinion).
In previous versions, if the "low minimum element quality" warning arises then a small yellow triangle would show up somewhere in the mesh node.
In 4.4, this is not the case, and the warning is only shown in the "Log" tab.
Regards,
I just noticed a disturbing thing in COMSOL 4.4 (the equivalent of windows 8 in terms of GUI horribleness in my opinion).
In previous versions, if the "low minimum element quality" warning arises then a small yellow triangle would show up somewhere in the mesh node.
In 4.4, this is not the case, and the warning is only shown in the "Log" tab.
Regards,
1 Reply Last Post 25 févr. 2014, 02:21 UTC−5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi,
As far as I can see, this is not a problem that is specific to version 4.4. The warning about "Low minimum element quality" appears in the Log window if the mesh quality of any mesh element is below 1e-4, whereas a Warning node for inverted elements appears if any mesh element is inverted; that is, its mesh quality is <=0.
Probably the mesh quality in version 4.4 is somewhat better than before so that the minimum element quality is >0 but still <1e-4, but without access to the model it's hard to say.
Best regards,
Magnus Ringh, COMSOL
As far as I can see, this is not a problem that is specific to version 4.4. The warning about "Low minimum element quality" appears in the Log window if the mesh quality of any mesh element is below 1e-4, whereas a Warning node for inverted elements appears if any mesh element is inverted; that is, its mesh quality is <=0.
Probably the mesh quality in version 4.4 is somewhat better than before so that the minimum element quality is >0 but still <1e-4, but without access to the model it's hard to say.
Best regards,
Magnus Ringh, COMSOL