Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Mesh Problem caused by Internal geometry problem: Boolean operation "Difference" causes problem
Posted 18 févr. 2014, 12:53 UTC−5 Geometry, Mesh, Studies & Solvers Version 4.3, Version 4.3b 1 Reply
Please login with a confirmed email address before reporting spam
Hello everyone,
I am trying to model a simple Shell and Tube heat exchanger.
-Errors: Inverted elements, failed to create boundary layers, ... during meshing
-Pictures of problems, the geometry, etc. are added !
-The domain that fails is the fluid over the tubes. This domain has two numbers: 3 & 4 like showed in added pictures. Is this some problem that this domain is twice defined by itself?
Thanks a lot !!
Hopefully someone will be able to solve this :)
Greetings
I am trying to model a simple Shell and Tube heat exchanger.
-Errors: Inverted elements, failed to create boundary layers, ... during meshing
-Pictures of problems, the geometry, etc. are added !
-The domain that fails is the fluid over the tubes. This domain has two numbers: 3 & 4 like showed in added pictures. Is this some problem that this domain is twice defined by itself?
Thanks a lot !!
Hopefully someone will be able to solve this :)
Greetings
Attachments:
1 Reply Last Post 19 févr. 2014, 07:33 UTC−5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
I found the problem, but doesn't know how to solve it.
Geometry problem with boolean operation "difference" causes meshing problem.
For the model it's necessary to obtain a domain of fluid over the tubes. That's why I make a difference between the whole cylinder and the tubes. Seen as in the attached pictures.
How to make such domain without causing this internal geometry problem??
This domain is needed to select fluid properties and inlets and outlets etc.
Geometry problem with boolean operation "difference" causes meshing problem.
For the model it's necessary to obtain a domain of fluid over the tubes. That's why I make a difference between the whole cylinder and the tubes. Seen as in the attached pictures.
How to make such domain without causing this internal geometry problem??
This domain is needed to select fluid properties and inlets and outlets etc.
Attachments: