Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

coupling two-phase laminar and turbulent model

Posted 19 nov. 2013, 00:31 UTC−5 Fluid & Heat Version 4.3b 0 Replies

Tsung-Hsing Hsu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi

I'm new to COMSOL and I would like to build a model for my experiment. Based on the simulation result, I believe I need to use two phase laminar model to run the simulation in the beginning and let turbulent model to take over the rest of simulation after a certain time point. If you have any suggestions for me, it would be greatly appreciated. Thank you.


Kevin
0 Replies Last Post 19 nov. 2013, 00:31 UTC−5
COMSOL Moderator

Hello Tsung-Hsing Hsu

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content