Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Modeling Multi-turn circular coil

Posted 13 août 2013, 10:27 UTC−4 Low-Frequency Electromagnetics, RF & Microwave Engineering, Geometry Version 4.2a 0 Replies

Cai Jin Lui
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I would like to model a multi-turn circular coil as shown in the picture.

However, i am confused with the modeling procedure. My objective is to perform RF coil simulating in Comsol.
As that i am new to Comsol Multiphysics, i tried many methods and still cant get it.

Hoping for a step by step guidance in modeling geometry. Thank you very much.
0 Replies Last Post 13 août 2013, 10:27 UTC−4
COMSOL Moderator

Hello Cai Jin Lui

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content