Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Setting convergence condition in fluid simulations

Posted 12 août 2013, 08:46 UTC−4 Fluid & Heat 0 Replies

Neehar Moharana
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear Sir/Madam

I'm a novice in COMSOL use. I have a question regarding convergence in fluid flow simulations.
I know that in FLUENT one has the possibility to set the divergence of velocity field to a lower limit. Does COMSOL too give something similar provision. My need is to have a velocity field where the velocity divergence condition has been satisfied to 1e-8 atleast. Do I need to buy an extra module ?


Best Regards

Neehar
0 Replies Last Post 12 août 2013, 08:46 UTC−4
COMSOL Moderator

Hello Neehar Moharana

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content