Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Creating geometry with loop

Posted 31 mai 2013, 16:09 UTC−4 2 Replies

Alberto Garcia-Cristobal
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear All


I am doing some calculations in Mechanics module. My problem is how to create circle with different radius R1.......Rn and do calculation for each radii in loop.


Regards,
A



2 Replies Last Post 31 mai 2013, 16:40 UTC−4
Josh Thomas Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 31 mai 2013, 16:14 UTC−4
Alberto-

Use Definitions>Parameters and define your radius as a parameter.

Then, under the Study node right-click and add "Parametric Sweep" node. Then, add the range of which radii you would like to solve for.

Best regards,
Josh Thomas
AltaSim Technologies
Alberto- Use Definitions>Parameters and define your radius as a parameter. Then, under the Study node right-click and add "Parametric Sweep" node. Then, add the range of which radii you would like to solve for. Best regards, Josh Thomas AltaSim Technologies
Alberto Garcia-Cristobal
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 31 mai 2013, 16:40 UTC−4
Dear Josh

Thank you, you solved my problems . Have nice weekend !



Regards,
A.
Dear Josh Thank you, you solved my problems . Have nice weekend ! Regards, A.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content