Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

the unit of volume flow

Posted 28 mai 2013, 10:09 UTC−4 Version 4.3a 2 Replies

Leilei Hu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam


Dear sir or madam,


I have a problem about the unit of volume flow. I know the standard liters per minute (slm) is
widely used in industry. So do we use this unit in comsol?

For example, if I give 20 [L/min] in 200 centidegrees, is 20 the value under standard condition
or current condition ?

Thank you very much.
2 Replies Last Post 30 mai 2013, 06:33 UTC−4
Nagi Elabbasi Facebook Reality Labs
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 29 mai 2013, 18:53 UTC−4
There are several options in COMSOL for selecting an inlet volume flow rate boundary condition. You can input a volume flow rate measured at standard temperature and pressure (or under other non-standard values if you play around with the settings). To access these options set Boundary Condition type of the inlet boundary condition to Mass Flow and you will find a lot of settings.

Nagi Elabbasi
Veryst Engineering
There are several options in COMSOL for selecting an inlet volume flow rate boundary condition. You can input a volume flow rate measured at standard temperature and pressure (or under other non-standard values if you play around with the settings). To access these options set Boundary Condition type of the inlet boundary condition to Mass Flow and you will find a lot of settings. Nagi Elabbasi Veryst Engineering
Leilei Hu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 30 mai 2013, 06:33 UTC−4
Thank you very much for your information !
Thank you very much for your information !

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content