Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

output not saved

Posted 7 mars 2013, 17:06 UTC−5 Version 4.2a 2 Replies

Mehdi Eliassi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have been running a number of long running transient cases.I ensure that I output the results often enough. However, I have noticed that if I kill the job, before it's complete, none of the output times are saved. Any idea why that is?
2 Replies Last Post 7 mars 2013, 17:37 UTC−5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 7 mars 2013, 17:14 UTC−5
Hi

use the stop buttons and not the red kill one

--
Good luck
Ivar
Hi use the stop buttons and not the red kill one -- Good luck Ivar
Mehdi Eliassi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 7 mars 2013, 17:37 UTC−5
Thanks. I used to have the stop button, but I no longer see it. Perhaps I need to look in the preferences.
thansk again.
Thanks. I used to have the stop button, but I no longer see it. Perhaps I need to look in the preferences. thansk again.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content