Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Rotating domain, Sliding wall, V=RW

Please login with a confirmed email address before reporting spam

Hello,

I am trying to understand how to set-up my case in COMSOL. Assume that you have a sphere that is located in a box. The sphere is rotating with X rpm in the box. Do you use the rotating machinery module and using the moving mesh in COMSOL at the boundary of the stationary and moving domains? or you just consider stationary domain and give no slip boundary condition with moving wall values (V=rw) at the interface without considering the moving mesh and domain?

Also, if my geometry is an assembly, do you use form assmebly or union in my case? I am thinking of from assembly as I have better control on my mesh (different domains with various mesh control). Does this approach make sense?

I need to solve heat trasnfer and fluid mechanics (CFD) in my study.

Thank you,


0 Replies Last Post 23 mars 2022, 15:16 UTC−4
COMSOL Moderator

Hello Hoo E

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.