Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

numerical error electrostatics with particle tracing

Posted 26 nov. 2021, 23:34 UTC−5 Low-Frequency Electromagnetics, Charged Particle Tracing 0 Replies

Konstantin Borisov
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

hello,

I was running a simulation with electrostatics and particle tracing module combined. the model is simple has only two surfaces charged to a voltage potential and electrons released. The model gives an error. it seems each time a particle touches the surface with voltage potential, comsol gives an error.

numerical error, with the domain numer referenced to the surface with the voltage potential.

is there any way to preven comsol to abort simulations at such event? is ther anything i can do to avoid this error?

thanks for your help

0 Replies Last Post 26 nov. 2021, 23:34 UTC−5
COMSOL Moderator

Hello Konstantin Borisov

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content