Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Helix with arbitrary cross-section

Posted 1 févr. 2010, 09:36 UTC−5 3 Replies

Bjarte Lofnes Hauge
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I have used the command helix3 from MATLAB in order to model a helix-shaped coil. I am also trying to model a band coil, with rectangular cross section. Are there any way to make a helix with a cross section that is not circular, such as revolving with an offset in z-direction?

Any help or alternative solution will be appreciated.
3 Replies Last Post 23 mars 2010, 05:37 UTC−4
COMSOL Moderator

Hello Bjarte Lofnes Hauge

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

GuRu@BFI
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 23 mars 2010, 05:37 UTC−4
I have a very similar problem. I want to generate a 3D helix geometry with rectengular section.
I have a very similar problem. I want to generate a 3D helix geometry with rectengular section.
GuRu@BFI
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 23 mars 2010, 05:37 UTC−4
I have a very similar problem. I want to generate a 3D helix geometry with rectengular section.
I have a very similar problem. I want to generate a 3D helix geometry with rectengular section.
GuRu@BFI
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 23 mars 2010, 05:37 UTC−4
I have a very similar problem. I want to generate a 3D helix geometry with rectengular section.
I have a very similar problem. I want to generate a 3D helix geometry with rectengular section.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content