Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

S-Parameters and PML

Posted 25 janv. 2010, 05:41 UTC−5 1 Reply

Elif
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear All,

I would like to calculate S-parameters for my model, however, I don't know how can I achieve this when the geometry is surrounded with PML. I cannot use port boundary condition and PML at the same time.

I would appreciate any help.
Thanks in advance,
Elif
1 Reply Last Post 21 avr. 2017, 10:41 UTC−4
COMSOL Moderator

Hello Elif

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Lena Ebers
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 21 avr. 2017, 10:41 UTC−4
Hello,

did you get any results yet?
Im facing the same problem.

Best regards, Lena
Hello, did you get any results yet? Im facing the same problem. Best regards, Lena

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content