Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Issue with Parametric Study using Adaptive Mesh Refinement

Posted 16 avr. 2012, 10:34 UTC−4 Computational Fluid Dynamics (CFD), Microfluidics Version 4.2a 0 Replies

Ryan McDevitt
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I've been simulating a microfluidic system using the level set method in 4.2a and have run into an issue where COMSOL only saves part of the solutions when doing a parametric study using the adaptive mesh refinement. Specifically, it saves exactly the last 10% for all of the parameters except the last one simulated, where it saves 100% of the time step data.

I've done the parametric study using a mapped mesh, which saved every time step for all parameter values. I've done a simulation using the adaptive mesh refinement for one of the parameter values and had access to all of the time step values. When I combine the two, however, I lose the first 90% of the time steps for most of the parameter values.

Any thoughts?
0 Replies Last Post 16 avr. 2012, 10:34 UTC−4
COMSOL Moderator

Hello Ryan McDevitt

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content