Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

parameterize glass fiber taper?

Posted 24 mars 2012, 22:48 UTC−4 Geometry Version 4.2a 0 Replies

phys314
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I'm trying to optimize the taper of a glass fiber in a mirror suspension application. But to do that I need to parameterize the fiber. I've tried to create the solid 3D fiber with a parameterized 2D curve and a Convert to Solid node, but that doesn't seem to work, Comsol can't mesh the solid fibers. When I change the model to an a Assembly instead of a Union, it meshes everything and my Frequency study runs, but I run into this problem: www.comsol.de/community/forums/general/thread/27125/#p73707

Any suggestions?
0 Replies Last Post 24 mars 2012, 22:48 UTC−4
COMSOL Moderator

Hello phys314

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content