Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Surface Integration in COMSOL
Posted 13 mars 2012, 20:17 UTC−4 Geometry, Results & Visualization Version 4.2a 1 Reply
Please login with a confirmed email address before reporting spam
Hi
I am modelling a 2D porous media of known grain sizes. In this regard I am aiming to find the permeability of this mediam in Darcy.
In this regard if I look at the Results--> Derived Values-->surface integration in COMSOL, then the software asked me to select the domain. Then when I put 1 in the expression, the next tab is units. 2 different units are present there, one is m2 and other is mD. Just wants to check if this mD stands for millidarcy? is that my pereability value? or I have to made some other modification?
I am modelling a 2D porous media of known grain sizes. In this regard I am aiming to find the permeability of this mediam in Darcy.
In this regard if I look at the Results--> Derived Values-->surface integration in COMSOL, then the software asked me to select the domain. Then when I put 1 in the expression, the next tab is units. 2 different units are present there, one is m2 and other is mD. Just wants to check if this mD stands for millidarcy? is that my pereability value? or I have to made some other modification?
1 Reply Last Post 14 mars 2012, 02:30 UTC−4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
not sure about that "D" is normally the Debye (dipole moment" Check the doc do a search for "units" or for "SI Base, Derived, and Other Units"
--
Good luck
Ivar
not sure about that "D" is normally the Debye (dipole moment" Check the doc do a search for "units" or for "SI Base, Derived, and Other Units"
--
Good luck
Ivar