Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Hanging Node in Planar Inductor Model

Posted 14 août 2020, 22:20 UTC−4 Electromagnetics, Low-Frequency Electromagnetics Version 5.4 0 Replies

Calvin Lin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have a planar inductor model and am trying to simulate the geometry coil analysis. But for some reason I'm getting the following error:

"Errors when compiling equations:

Inconsistent circuit setup. The circuit contains hanging nodes.

-Node name: 0 -Feature: Ground Node 1 (gnd1)."

Attachments:

0 Replies Last Post 14 août 2020, 22:20 UTC−4
COMSOL Moderator

Hello Calvin Lin

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content