Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Help with a model combining laminar flow of a fluid and diffusion

Posted 20 juil. 2011, 14:49 UTC−4 0 Replies

Steven Goglia
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello everyone, I am currently working with a basic transport model. It is composed of two gases flowing through two micro-channels in a block of PDMS. Modeling diffusion is my goal, any advice?
I know the diffusion coeficients for N2 and O2 diffusing into the PDMS; however, I do not know the Dij for O2 diffusing into N2 as they both diffuse into the PDMS. In addition, the volumetric flow-rate of N2 is 10 to 20 times that of O2. I determined the flux from the equations in Perry's but I am not sure that the model is set up right. Thanks and have great day!

0 Replies Last Post 20 juil. 2011, 14:49 UTC−4
COMSOL Moderator

Hello Steven Goglia

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content