Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Fatigue module message "Stress cycle defined by stress amplitude "

Posted 7 sept. 2017, 19:25 UTC−4 1 Reply

Alfredo Rodriguez
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I'm using the fatigue module to evaluate the results from a solid mechanics object. However, I get the following warning message: "Stress cycle defined by stress amplitude 285686239.1227691 encountered. Fatigue cannot be evaluated ". I get a Cycles to Failure plot, but an area of the object appears empty.

Any ideas on what might be producing this warning?

I mighty upload the model later if required, the computer I'm using eighty now doesn't want to load the forum page, so I'm posting from my phone.

Thanks for any help,

Alfredo
1 Reply Last Post 11 sept. 2017, 02:57 UTC−4
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 11 sept. 2017, 02:57 UTC−4
Hi,

The stress amplitude is too large. It is outside the range of the S-N curve, in the sense that the predicted number of cycles will be <1.

Regards,
Henrik
Hi, The stress amplitude is too large. It is outside the range of the S-N curve, in the sense that the predicted number of cycles will be

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content