Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Meshing using a meshfile

Posted 28 févr. 2011, 08:19 UTC−5 Interfacing, Geometry, Mesh Version 4.1 0 Replies

Michael Rembe Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello, is there anybody who has experiences using a meshfile? For a sequence of simulation runs with a growing geometry I create a meshfile (by aid of a matlab code) similar to the mesh file of comsol after mesh export.

The 3d-geometry has 9 boundaries and I set up the faces using the number of domains "n-faces # number of domains".

It runs in x simulations, but now I have the problem, that comsol is doing a face partitioning. I can control the face partioning using "Face partitioning manual", but I don't get the same result I defined in my mesh file.

I'm not able to find out the reason for the face partitioning and I can not prevent comsol to do so in this case.

Is there anybody to give me a hint?

Thank you very much!

MIchael Rembe
0 Replies Last Post 28 févr. 2011, 08:19 UTC−5
COMSOL Moderator

Hello Michael Rembe

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content